Lighting a gas fireplace. Most gas fireplaces have a standing pilot light which is a small flame that burns even when you arent using the fireplace. There are a few steps to turn them on including finding the gas control valve turning that on and then finding the igniter button to light the fire. Air out the fireplace before lighting it.
When lighting the pilot follow these instructions exactly. Cold air is heavier than warm air so if the outside is too cold it can create a river of cold air flowing down the chimney into the fireplace and trapped there by the doors. I just had it serviced getting the themro couple replaced and it was working yesterday went to switch it on this morning and it wouldnt ignite the pilot light is on.
Now you are ready to. Gas fireplaces dont use the same steps as manual fireplaces. Before lighting smell around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier than air and. Procom split hickory ventless gas logs manual control 18 or 24 inch natural gas only the new fireplace is very nice looking and puts out a ton of heat. There could be multiple factors causing a single issue so covering all your bases and eliminating potential culprits can be time consuming and requires a level of expertise.
If your fireplace has glass doors open the doors 15 to 20 minutes before lighting your fire. Gas fireplace wont light up the pilot light is working but when i switch the wall switch to on the fireplace wont start what could the problem be. To keep yourself from getting injured stay vigilant at all times and adhere to any safety instructions mentioned in your fireplaces user manual.
This will allow the inside of the fireplace to come to room temperature. This makes the fireplace easy to start when its cold outside but when it warms up its a good idea to shut off the pilot to conserve gas. Gas fireplace repair can be daunting.
Make sure that the gas is on before turning on your new fireplace. So even if you have had a fireplace in the past the lighting process may not be the same. If nothing happens and the gas is on turn the gas off again and call a technician for an inspection and service.